Compaq ProLiant ML570 User Manual

3-20 Compaq ProLiant ML570 Maintenance and Service Guide
Table 3-2
POST Error Messages
continued
Error Code Audible Beeps Probable Source of Problem Recommended Action
1794-Drive Array –
Array Accelerator
Battery Charge Low.
Array Accelerator is
temporarily disabled.
Array Accelerator will
be re-enabled when
battery reaches full
charge.
None A warning that the battery charge
is below 75%. Posted-writes are
disabled.
Replace the array accelerator
board if batteries do not
recharge while the system has
been powered up for 36 hours.
1795-Drive Array –
Array Accelerator
Configuration Error.
Data does not
correspond to this
drive array. Array
Accelerator is
temporarily disabled.
None Indicates that while the system
was in use, power was
interrupted while data was in the
array accelerator memory.
The data stored in the array
accelerator does not correspond
to this drive array.
Match the array accelerator to
the correct drive array, or run
the System Configuration Utility
to clear the data in the array
accelerator.
1796-Drive Array –
Array Accelerator Not
Responding.
Array Accelerator is
temporarily disabled.
None Array accelerator is defective or
has been removed.
1. Check that the array
accelerator is properly
seated.
2. Run the System
Configuration Utility to
reconfigure the Compaq
IDA-2 without the array
accelerator.
1797-Drive Array –
Array Accelerator
Read Error Occurred.
Data in Array
Accelerator has been
lost. Array
Accelerator is
disabled.
None Hard parity error while reading
data from posted-writes
memory.
Enable array accelerator.
1798-Drive Array –
Array Accelerator
Write Error Occurred.
Array Accelerator is
disabled.
None Hard parity error while writing
data to posted-writes memory.
Enable array accelerator.
continued

Compaq ProLiant ML570 Specifications

General

Brand	Compaq
Model	ProLiant ML570
Category	Server
Language	English