Compaq ProLiant ML570 User Manual

3-12 Compaq ProLiant ML570 Maintenance and Service Guide
Table 3-2
POST Error Messages
continued
Error Code Audible Beeps Probable Source of Problem Recommended Action
1622-Internal SCSI
Jumper Board Not
Installed
None The system has detected that the
array enabler board is not
installed.
Install the array enabler board.
1703-SCSI cable
error detected.
Internal SCSI cable
not attached to
system board
connector. System
halted.
None Incorrect cabling Ensure that the integrated SCSI
controller has SCSI termination
attached.
1703-SCSI Cable
Error Detected
Terminated cable
attached to output
connector of SCSI
backplane.
System Halted
None Terminated cable has
erroneously been attached to the
output connector of the SCSI
backplane.
Remove the terminated cable.
1703-SCSI Cable
Error Detected
Must be configured
for Single backplane,
Simplex or Duplex
System Halted
None SCSI cables have been
connected in an unsupported
configuration.
Reconnect the SCSI cables in a
supported configuration.
1703-SCSI Cable
Error Detected
Simplex Mode
detected, but LED
cable not installed
System Halted
None LED cable has failed or is not
connected properly.
Reconnect or replace the LED
cable.
1720-Slot x Drive
Array – SMART Drive
Detects Imminent
Failure SCSI: Port y:
SCSI ID x
None Indicated drive has reported a
SMART predictive-failure
condition and may fail at some
time in the future.
If drive is part of a
nonfault-tolerant configuration,
back up all data before
replacing drive and restore all
data afterward. If drive is part of
a fault-tolerant configuration
do not replace drive unless all
other drives in array are online.
Press F1 to resume.
continued

Compaq ProLiant ML570 Specifications

General

Brand	Compaq
Model	ProLiant ML570
Category	Server
Language	English