EasyManuals Logo

Compaq ProLiant ML570 User Manual

Compaq ProLiant ML570
199 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #151 background imageLoading...
Page #151 background image
3-74 Compaq ProLiant ML570 Maintenance and Service Guide
6. The server analyzes the diskette, searching for the latest ROM image. If the diskette is not
in place, the system continues to beep until a valid ROMPaq diskette is inserted.
7. The ROMPaq diskette flashes the system ROM.
8. At the successful completion of this process, a sequence of audible ascending beeps is
generated.
9. After successful completion of this process, follow these steps:
a. Power down the server.
b. Reset configuration switches.
c. Power up the server as usual.
Or
After a failed ROMPaq upgrade procedure, power down the server and repeat the
above process.
IMPORTANT: If you are performing this procedure on a server with redundant ROM, and both ROM
images have been corrupted, repeat the process in succession (once for each corrupted image). If only
one image is corrupted, read the following section, Redundant ROM Image Recovery for complete
instructions.
Redundant ROM Image Recovery
If power is interrupted during the flash process, a server with redundant ROM powers up as
usual, but the inactive (redundant) ROM image is corrupted.
A POST error message displays:
105 Current System ROM is corrupt now booting redundant System ROM.
In this instance, you are required to flash again so that the invalid image is now valid. After you
flash the invalid image, the system boots to that imagewhich was the original objective.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Compaq ProLiant ML570 and is the answer not in the manual?

Compaq ProLiant ML570 Specifications

General IconGeneral
BrandCompaq
ModelProLiant ML570
CategoryServer
LanguageEnglish

Related product manuals