Compaq ProLiant ML570 - Page 94

Diagnostics and Troubleshooting 3-17
Table 3-2
POST Error Messages
continued
Error Code Audible Beeps Probable Source of Problem Recommended Action
1785-Drive Array not
Configured
None Configuration error All following actions are related
to error 1785 with specific
descriptions.
Run Compaq Array
Configuration Utility
None Configuration error Run the Array
Configuration Utility.
No drives detected. None Configuration error Power down system and check
SCSI cable connections to make
sure drives are
attached properly.
Array Accelerator
Memory Size
Increased.
None Configuration error Run the System
Configuration Utility.
External Cable(s)
Attached to Wrong
SCSI Port
Connector(s).
None Configuration error Power down system and swap
SCSI power connectors to
prevent data loss.
Drive positions
cannot be changed
during Capacity
Expansion.
None Configuration error Run Array Diagnostic Utility
(ADU) if previous positions are
unknown. Then power down
system and move drives to their
original positions.
Drive positions
appear to have
changed.
None Configuration error Run Array Diagnostic Utility
(ADU) if previous positions are
unknown. Then power down the
system and move drives to their
original positions.
Configuration
information indicates
drive positions
beyond the capability
of this controller.
This may be due to
drive movement from
a controller that
supports more drives
than the current
controller.
None Configuration error To avoid data loss, power down
and reattach drives to the
original controller.
Configuration
information indicates
drives were
configured on a
controller with a
newer firmware
version.
None Configuration error To avoid data loss, reattach
drives to original controller or
upgrade controller firmware to
the version of the original
controller using Option ROMPaq.
Press F1 to resume.
continued