EasyManua.ls Logo

D-Link DFL-870

D-Link DFL-870
328 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
LogResolveFailure Specifies whether or not to log failed ARP Resolves.
(Default: Yes)
NDRateLimit Rate limit originated ND packets. (Default: 1000)
MaxAnycastDelayTime Randomized time to delay proxied and anycast
advertisements. (Default: 100)
NDMatchEnetSender Ignore ND packets with mismatching sender- and
options MAC-addresses. (Default: Yes)
NDValSenderIP Validate the IP source address of the ND packet.
(Default: Yes)
NDLogResolveSuccess Specifies whether or not to log when ND Resolve
succeeds. (Default: No)
NDChanges Action to take when ND packets are received that
would modify an existing entry. (Default: FavorOld)
StaticNDChanges Action to take when ND packets are received that
would modify a static entry. (Default: DropLog)
NDValidation Action to take when the stateless validation of a
ND packet fail. (Default: DropLog)
NDCacheSize Number of cached IP/L2 address tuples. (Per iface).
(Default: 1024)
NDMaxMulticastSolicit Number of Neighbor Solicitations before giving up
address resolution. (Default: 3)
NDMaxUnicastSolicit Number of Neighbor Solicitations before giving up
a zombie during dead peer detection. (Default: 3)
NDBaseReachableTime Multiple of randomized time factor in seconds,
resulting in the time before a ND entry becomes a
zombie. (Default: 30)
NDDelayFirstProbeTime Time in seconds for a cache entry to go from
DELAY to PROBE state unless resolved. (Default: 5)
NDRetransTimer Number of seconds between each Neighbor
Solicitation during address resolution and dead
peer detection. (Default: 1)
RAMaxInterval Maximum time between sending unsolicited
multicast Router Advertisement. (Default: 600s).
(Default: 600)
RAMinInterval Minimum time between sending unsolicited
multicast Router Advertisement. Will be
automatically adjusted if set to less than 3 seconds
or greater than .75 * Max RA Interval). (Default: 200)
RAAutoLifetime Auto adjust the Router Lifetime field using the
following formula; 3 * Max RA Interval. (Default:
Yes)
RADefaultLifetime The value to be placed in the Router Lifetime field
of Router Advertisements sent from the SGW, in
seconds. (Default: 1800s). (Default: 1800)
Chapter 3: Configuration Reference
132

Table of Contents

Other manuals for D-Link DFL-870

Related product manuals