EasyManua.ls Logo

D-Link DFL-870

D-Link DFL-870
328 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3.39. EthernetSettings
Description
Settings for Ethernet interface.
Properties
DHCP_MinimumLeaseTime Minimum lease time (seconds) accepted from the
DHCP server. (Default: 60)
DHCP_ValidateBcast Require that the assigned broadcast address is the
highest address in the assigned network. (Default:
Yes)
DHCP_AllowGlobalBcast Allow DHCP server to assign 255.255.255.255 as
broadcast (Non-standard). (Default: No)
DHCP_UseLinkLocalIP Use a 169.254.*.* IP while waiting for a lease
(instead of 0.0.0.0). (Default: No)
DHCP_DisableArpOnOffer Disable arp resolve on offers (normally used to
verify that an IP is not occupied). (Default: No)
Ringsize_e1000_rx Size of e1000 receive ring (per interface). (Default:
128)
Ringsize_e1000_tx Size of e1000 send ring (per interface). (Default:
256)
Ringsize_r8169_rx Size of r8169 receive ring (per interface). (Default:
256)
Ringsize_r8169_tx Size of r8169 send ring (per interface). (Default:
256)
IfaceMon_e1000 Enable interface monitor for e1000 interfaces.
(Default: Yes)
IfaceMon_BelowCPULoad Temporarily disable interface monitor if CPU load
goes above this percentage. (Default: 80)
IfaceMon_BelowIfaceLoad Temporarily disable interface monitor on an
interface if network load on the interface goes
above this percentage. (Default: 70)
IfaceMon_MinInterval Minimum interval between two resets of the same
interface. (Default: 30)
IfaceMon_RxErrorPerc At what percentage of errors to received packets to
declare a problem. (Default: 20)
IfaceMon_TxErrorPerc At what percentage of errors to sent packets to
declare a problem. (Default: 7)
IfaceMon_ErrorTime How long a problem must persist before an
interface is reset. (Default: 10)
Chapter 3: Configuration Reference
174

Table of Contents

Other manuals for D-Link DFL-870

Related product manuals