3.77. LinkAggregation
Description
A Link Aggregation interface combines multiple Ethernet interfaces into a single logical
endpoint.
Properties
Name Specifies a symbolic name for the interface.
(Identifier)
Members A set of Ethernet interfaces to aggregate.
(Optional)
DistributionAlgorithm Specifies how outgoing traffic will be distributed
among the active links. (Default: Combination)
Mode Specifies the method used to aggregate links.
(Default: Static)
LACPActivity Specifies if the system should actively attempt to
initiate LACP negotiations or wait for a partner
system to do so. (Default: Active)
LACPTimeout Specifies how soon the system will reselect active
links if a link is broken. (Default: Long)
LACPSystemPriority System priority value to be sent in LACP messages.
(Default: 1)
MACAddress The hardware address for the interface. (Optional)
IP The IP address of the interface.
Network The network of the interface.
DefaultGateway The default gateway of the interface. (Optional)
Broadcast The broadcast address of the connected network.
(Optional)
EnableIPv6 Enable processing of IPv6 traffic on this interface.
(Default: No)
IPv6IP The IP address of the interface.
IPv6Network The network of the interface.
IPv6DefaultGateway The default gateway of the interface. (Optional)
RouterDiscovery Uses Router information (ND RA) from local
network to auto-configure Network and Default
Gateway addresses. (Default: No)
AutoIPv6IP Automatically configures IP Address using Network
Address and EUI-64. (Default: No)
DHCPv6Enabled Enable DHCPv6 client on this interface. (Default:
No)
Chapter 3: Configuration Reference
238
To Next Page
Loading...
