3.102. RemoteMgmtSettings
Description
Setup and configure methods and permissions for remote management of this system.
Properties
NetconBiDirTimeout Specifies the amount of seconds to wait for the
administrator to log in before reverting to the
previous configuration. (Default: 30)
WebUIBeforeRules Enable HTTP(S) traffic to the firewall regardless of
configured IP Rules. (Default: Yes)
WWWSrv_HTTPPort Specifies the HTTP port for the web user interface.
(Default: 80)
WWWSrv_HTTPSPort Specifies the HTTPS port for the web user interface.
(Default: 443)
WebUIAllowLoginAutoComplete Allow the web browser to remember the username
and password on the login page. (Default: Yes)
SSHBeforeRules Enable SSH traffic to the firewall regardless of
configured IP Rules. (Default: Yes)
HTTPSCertificate Specifies host certificate to use for HTTPS traffic.
Only RSA certificates are supported. (Optional)
HTTPSRootCertificates Specifies eventual root certificates to use for HTTPS
traffic. (Optional)
SNMPBeforeRules Enable SNMP traffic to the firewall regardless of
configured IP Rules. (Default: Yes)
SNMPRequestLimit Maximum number of SNMP packets that will be
processed each second. (Default: 100)
SNMPSysContact The contact person for this managed node.
(Default: N/A)
SNMPSysName The name for this managed node. (Default: N/A)
SNMPSysLocation The physical location of this node. (Default: N/A)
SNMPIfDescription What to display in the SNMP MIB-II ifDescr
variables. (Default: Name)
SNMPIfAlias What to display in the SNMP ifMIB ifAlias variables.
(Default: Hardware)
LocalConsoleIdleTimeout Number of seconds of inactivity until the local
console user is automatically logged out. (Default:
900)
WebUIIdleTimeout Number of seconds of inactivity until the HTTP(S)
session is closed. (Default: 900)
SNMPPersistentIfIndexes Make SNMP interface indexes persistent over
Chapter 3: Configuration Reference
274
To Next Page
Loading...
