3.59. IP6in4Tunnel
Description
A 6in4 tunnel (no encryption, no authentication, only encapsulation) allows tunneling of IPv6
packets over an existing IPv4 network.
Properties
Name Specifies a symbolic name for the interface.
(Identifier)
IP Specifies the IPv6 address of the 6in4 tunnel
interface.
Network Specifies the remote IPv6 network of the 6in4
interface.
RemoteEndpoint Specifies the IPv4 address of the remote endpoint.
OriginatorIPType Specifies what IPv4 address to use as source IP for
the encapsulated IPv6 packets. (Default:
LocalInterface)
OriginatorIP Manually specified IPv4 address to use as source IP
for the encapsulated IPv6 packets.
Metric Specifies the metric for the auto-created route.
(Default: 90)
AutoInterfaceNetworkRoute Automatically add a route for this interface using
the given remote network. (Default: Yes)
MTU Specify the Maximum Transmission Unit for IPv6
packets entering this tunnel. (Default: 1280)
OutgoingRoutingTable The outer PBR Table to use when communicating
with the remote endpoint. (Default: main)
SNMPIndex Interface index assigned by the system when
persistent interface indexes are enabled. (Default:
0)
MemberOfRoutingTable All or Specific. (Default: All)
RoutingTable Specifies the PBR table to insert the interface IP
route into. It also means that the specified routing
table will be used for all routing lookups, unless
overridden by a PBR rule. (Default: main)
Comments Text describing the current object. (Optional)
Chapter 3: Configuration Reference
199
To Next Page
Loading...
