3.128. VLAN
Description
Use a VLAN to define a virtual interface compatible with the IEEE 802.1Q / 802.1ad Virtual LAN
standard.
Properties
Name Specifies a symbolic name for the interface.
(Identifier)
VLANID The virtual LAN ID used for this virtual LAN
interface. Two virtual LANs cannot have the same
VLAN ID and type if they are based on the same
interface. (Default: 0)
BaseInterface Interface where this VLAN is being tunneled.
Type VLAN type. (Default: 0x8100)
IP The IP address of the virtual LAN interface.
Network The network address of the virtual LAN interface.
DefaultGateway The default gateway of the virtual LAN interface.
(Optional)
Broadcast The broadcast address of the virtual LAN interface.
(Optional)
DHCPEnabled Enable DHCP client on this interface. (Default: No)
DHCPHostName Optional DHCP Host Name. Leave blank to use
default name. (Optional)
DHCPDNS1 IP of the primary DNS server. (Optional)
DHCPDNS2 IP of the secondary DNS server. (Optional)
EnableIPv6 Enable processing of IPv6 traffic on this interface.
(Default: No)
IPv6IP The IPv6 address of the virtual LAN interface.
IPv6Network The IPv6 network of the virtual LAN interface.
IPv6DefaultGateway The default gateway of the virtual LAN interface.
(Optional)
RouterDiscovery Uses Router information (ND RA) from local
network to auto-configure Network and Default
Gateway addresses. (Default: No)
AutoIPv6IP Automatically configures IP Address using Network
Address and EUI-64. (Default: No)
DHCPv6Enabled Enable DHCPv6 client on this interface. (Default:
No)
Chapter 3: Configuration Reference
313
To Next Page
Loading...
