3.46. HighAvailability
Description
Configure the High Availability cluster parameters for this system.
Properties
Enabled Enable high availability. (Default: No)
ClusterID A (locally) unique cluster ID to use in identifying
this group of HA firewalls. (Default: 0)
SyncIface Specifies the interface used for state
synchronization.
NodeID Master or Slave. (Default: Master)
HASyncBufSize How much sync data, in KB, to buffer while waiting
for acknowledgments from the cluster peer.
(Default: 1024)
HASyncMaxPktBurst The maximum number of state sync packets to
send in a burst. (Default: 20)
HAInitialSilence The number of seconds to stay silent on startup or
after reconfiguration. (Default: 5)
UseUniqueSharedMac Use a unique shared mac address for each
interface. (Default: Yes)
HADeactivateBeforeReconf Deactivate(hand over) before Reconfiguration if
Active. (Default: Yes)
ReconfFailoverTime Number of non-responsive seconds before failover
at HA reconf (0=immediate failover). (Default: 0)
HAFailoverTime Number of milliseconds before failover when
active HA node becomes non-responsive. (Default:
750)
Note
This object type does not have an identifier and is identified by the name of the type
only. There can only be one instance of this type.
Chapter 3: Configuration Reference
183
To Next Page
Loading...
