Note
If no Index is specified when creating an instance of this type, the object will be placed
last in the list and the Index will be equal to the length of the list.
3.63.5. GotoRule
The definitions here are the same as in Section 3.44, “GotoRule” .
3.63.6. ReturnRule
Description
A return rule makes the IP rule scan resume from the goto rule that led to the current IP rule set.
If there was no goto rule leading to the current IP rule set the connection is dropped and rule
scanning stops.
Properties
Name Specifies a symbolic name for the rule. (Optional)
Action Return Action. (Default: Return)
SourceInterface Specifies the name of the receiving interface to be
compared to the received packet.
DestinationInterface Specifies the destination interface to be compared
to the received packet.
SourceNetwork Specifies the sender span of IP addresses to be
compared to the received packet.
DestinationNetwork Specifies the span of IP addresses to be compared
to the destination IP of the received packet.
Service Specifies a service that will be used as a filter
parameter when matching traffic with this rule.
Schedule By adding a schedule to a rule, the firewall will only
allow that rule to trigger at those designated times.
(Optional)
LogEnabled Enable logging. (Default: Yes)
LogSeverity Specifies with what severity log events will be sent
to the specified log receivers. (Default: Default)
Comments Text describing the current object. (Optional)
Note
If no Index is specified when creating an instance of this type, the object will be placed
last in the list and the Index will be equal to the length of the list.
Chapter 3: Configuration Reference
214
To Next Page
Loading...
