3.97. RadiusRelay
Description
RADIUS relay for intercepting packets from a user endpoint and sending packets to a remote
RADIUS server.
Properties
Name Specifies a symbolic name for the relayer.
(Identifier)
SourceInterface Specifies the name of the receive interface for
RADIUS relay requests.
ClientIPFilter Specifies the network that the AP belongs to.
ListeningIP Specifies the local IP address on which the system
receives Access Point requests. This parameter is
optional and will use IP of source interface, if not
set. (Optional)
ListeningPort Specifies the listening port on which the system
receives Access Point requests. (Default: 1812)
RemoteServerIP Specifies the IP address of the remote RADIUS
server.
RemoteServerPort Specifies the port of the remote RADIUS server.
(Default: 1812)
SendingIP Specifies the local IP address from which the
system sends requests to the remote Remote
RADIUS server. This parameter is optional and will
use IP of routed destination interface, if not set.
(Optional)
IdleTimeout A successfully authenticated user will be logged
out automatically after this many seconds, if no
traffic has been received from the user's IP address.
(Default: 1800)
SessionTimeout A successfully authenticated user will be logged
out automatically after this many seconds, even if
traffic has been received from the user's IP address.
(Default: 0)
UseServerTimeouts Use timeouts received from the authentication
server. If no values are received, the manually
specified values will be used. (Default: No)
DHCPServer Specifies the DHCP server rule that is responsible
for distributing leases for authenticated users.
OverrideUserDataInterface Optionally specify the source interface for the
authenticated user data. If not specified, the
configured RADIUS Relay source interface will be
used. (Optional)
Chapter 3: Configuration Reference
268
To Next Page
Loading...
