3.9. ARPNDSettings
Description
Advanced ARP/Neighbor Discovery-table settings.
Properties
ARPMatchEnetSender The Ethernet Sender address matching the
hardware address in the ARP data. (Default:
DropLog)
ARPQueryNoSenderIP If the IP source address of an ARP query (NOT
response!) is "0.0.0.0". (Default: DropLog)
ARPSenderIP The IP Source address in ARP packets. (Default:
Validate)
UnsolicitedARPReplies Unsolicited ARP replies. (Default: DropLog)
ARPRequests Specifies whether or not the ARP requests should
automatically be added to the ARP table. (Default:
Drop)
ARPChanges ARP packets that would cause an entry to be
changed. (Default: AcceptLog)
StaticARPChanges ARP packets that would cause static entries to be
changed. (Default: DropLog)
ARPExpire Lifetime of an ARP entry in seconds. (Default: 900)
ARPExpireUnknown Lifetime of an "unknown" ARP entry in seconds.
(Default: 3)
ARPMulticast ARP packets claiming to be multicast addresses;
may need to be enabled for some load
balancers/redundancy solutions. (Default:
DropLog)
ARPBroadcast ARP packets claiming to be broadcast addresses;
should never need to be enabled. (Default:
DropLog)
ARPCacheSize Number of ARP entries in cache, total. (Default:
4096)
ARPHashSize Number of ARP hash buckets per physical
interface. (Default: 512)
ARPHashSizeVLAN Number of ARP hash buckets per VLAN interface.
(Default: 64)
ARPIPCollision Behavior when receiving an ARP request with a
sender IP colliding with the one used on the
receive interface. (Default: Drop)
ARPLogResolveSuccess Specifies whether or not to log when ARP Resolve
succeeds. (Default: No)
Chapter 3: Configuration Reference
131
To Next Page
Loading...
