selftest
Show the status of a running test.
Options
-abort Abort a running self test.
-burnin Run burn-in tests for a selected set of sub tests.
-cryptoaccel Verify the correct functioning of available crypto
accelerator cards.
-hours[=<Integer>] Test duration in hours. (Default: 48)
-interfaces=<Interface> Ethernet interface(s).
-mac Check if there are MAC address collisions on the
interfaces.
-media Check the sanity of the disk drive.
-memory Check the sanity of the RAM.
-minutes[=<Integer>] Test duration in minutes. (Default: 0)
-num=<Integer> Number of times to execute the test. (Default: 1)
-ping Run a ping test over the interfaces.
-size=<Integer> Size of media space to utilize in the test. Set in MB.
(Default: 1)
-throughput Run a throughput test over the interfaces. This will
show the maximal achievable interface
throughput.
-traffic Run a traffic test over the interfaces. The traffic test
uses mixed frame sizes and verifies the content of
each received frame.
Note
Requires Administrator privileges.
2.2.75. services
Show runtime values of configured services.
Description
Shows the runtime values of all configured services.
Example 2.16. List all services which names begin with "http"
Chapter 2: Command Reference
81
To Next Page
Loading...
