3.110. RoutingTable
Description
The system has a predefined main routing table. Alternate routing tables can be defined by the
user.
Properties
Name Specifies a symbolic name for the routing table.
(Identifier)
Ordering Specifies how a route lookup is done in a named
routing table. (Default: Only)
RemoveInterfaceIPRoutes Removes the interface routes. Makes the firewall
completely transparent. (Default: No)
Comments Text describing the current object. (Optional)
3.110.1. Route
Description
A route defines what interface and gateway to use in order to reach a specified network.
Properties
Name Specifies a symbolic name for the object.
(Optional)
Interface Specifies which interface packets destined for this
route shall be sent through.
Gateway Specifies the IP address of the next router hop used
to reach the destination network. If the network is
directly connected to the firewall interface, no
gateway address is specified. (Optional)
LocalIP The IP address specified here will be automatically
published on the corresponding interface. This
address will also be used as the sender address in
ARP queries. If no address is specified, the firewall's
interface IP address will be used. (Optional)
Network Specifies the network address for this route.
BroadcastFwd By default, this traffic is dropped. (Default: No)
RouteMonitor Specifies if this route should be monitored for
route changes for route failover purposes. (Default:
No)
MonitorLinkStatus Mark the route as down if the interface link status
changes to down. (Default: No)
Chapter 3: Configuration Reference
285
To Next Page
Loading...
