-database Show the LSA database.
-execute={STOP | START | RESTART} Start/stop/restart OSPF process. (Admin only)
-iface Show interface information.
-ifacedown Take specified interface offline. (Admin only)
-ifaceup Take specified interface online. (Admin only)
-lsa Show details for a specified LSA <lsaID>.
-neighbor Show neighbor information.
-process=<OSPF Router Process> Required if there are >1 OSPF router processes.
-route Show the internal OSPF process routingtable.
-snoop={ON | OFF} Show troubleshooting messages on the console.
(Admin only)
-verbose Increase amount of information to display.
<interface> OSPF enabled interface.
<interface> OSPF enabled interface.
<lsaID> LSA ID.
<OSPF Area> OSPF Area.
<OSPF Neighbor> Neighbor.
{HA | ALT} Show HA routingtable.
2.2.63. pcapdump
Packet capturing.
Description
Packet capture engine
Usage
pcapdump
Show capture status.
pcapdump -start [<interface(s)>] [-size=<value>] [-snaplen=<value>]
[-count=<value>] [-out] [-out-nocap]
[-eth=<Ethernet Address>] [-ethsrc=<Ethernet Address>]
[-ethdest=<Ethernet Address>] [-ip=<IP4 Address>]
[-ipsrc=<IP4 Address>] [-ipdest=<IP4 Address>]
[-port=<0...65535>] [-srcport=<0...65535>]
[-destport=<0...65535>] [-proto=<0...255>] [-icmp] [-tcp]
[-udp] [-promisc] [-ipversion=<1...15>]
Chapter 2: Command Reference
71
To Next Page
Loading...
