3.89. NATPool
Description
A NAT Pool is used for NATing multiple concurrent connections to using different source IP
addresses.
Properties
Name Specifies a symbolic name for the NAT Pool.
(Identifier)
Type Specifies how NAT'ed connections are assigned a
NAT IP address. (Default: stateful)
IPSource Specify which IP Address source to use. (Default:
IPRange)
IPPool Specifies the IP Pool used for retrieving IP
addresses for NAT translation.
IPPoolIPs The number of IP addresses to get from the IP Pool.
IPRange Specifies the range of IP addresses used for NAT
translation.
StateKeepAlive The number of seconds that stateful NAT state will
be kept in absence of new connections. (Default:
120)
MaxStates Maximum number of statefully tracked NATPool
states. (Default: 16384)
ProxyARPAllInterfaces Always select all interfaces, including new ones, for
publishing routes needed for receiving traffic on
NATPool addresses. (Default: No)
ProxyARPInterfaces Specifies the interface/interfaces on which the
firewall should publish routes needed for the relay
via Proxy ARP. (Optional)
Comments Text describing the current object. (Optional)
Chapter 3: Configuration Reference
253
To Next Page
Loading...
