to the specified log receivers. (Default: Default)
Comments Text describing the current object. (Optional)
Note
If no Index is specified when creating an instance of this type, the object will be placed
last in the list and the Index will be equal to the length of the list.
3.63.3. MulticastPolicy
Description
Multiplex Static Address Translation. The Multicast rule is used to achieve duplication and
forwarding of packets through more than one interface.
Properties
Index The index of the object, starting at 1. (Identifier)
Name Specifies a symbolic name for the policy.
RequireIGMP Multicast traffic must have been requested using
IGMP before it is forwarded. (Default: Yes)
MultiplexArgument Specifies how the traffic should be forwarded and
translated.
MultiplexAllToOne Rewrite all destination IPs to a single IP. (Default:
No)
SourceInterface Specifies the name of the receiving interface to be
compared to the received packet.
DestinationInterface Specifies the destination interface to be compared
to the received packet.
SourceNetwork Specifies the sender span of IP addresses to be
compared to the received packet.
DestinationNetwork Specifies the span of IP addresses to be compared
to the destination IP of the received packet.
SourceGeoFilter Specifies the country filter to be compared against
the sender Geolocation of the received packet.
(Optional)
DestinationGeoFilter Specifies the country filter to be compared against
the destination Geolocation of the received packet.
(Optional)
Service Specifies a service that will be used as a filter
parameter when matching traffic with this rule.
Schedule By adding a schedule to a rule, the firewall will only
allow that rule to trigger at those designated times.
Chapter 3: Configuration Reference
211
To Next Page
Loading...
