SLBHTTPExpectedResponse Expected HTTP response. (Optional)
SLBDistribution Specifies the algorithm used for the load
distribution tasks. (Default: RoundRobin)
SLBWindowTime Specifies the window time used for counting the
number of seconds back in time to summarize the
number of new connections for connection-rate
algorithm. (Default: 10)
SourceInterface Specifies the name of the receiving interface to be
compared to the received packet.
DestinationInterface Specifies the destination interface to be compared
to the received packet.
SourceNetwork Specifies the sender span of IP addresses to be
compared to the received packet.
DestinationNetwork Specifies the span of IP addresses to be compared
to the destination IP of the received packet.
SourceGeoFilter Specifies the country filter to be compared against
the sender Geolocation of the received packet.
(Optional)
DestinationGeoFilter Specifies the country filter to be compared against
the destination Geolocation of the received packet.
(Optional)
Service Specifies a service that will be used as a filter
parameter when matching traffic with this rule.
Schedule By adding a schedule to a rule, the firewall will only
allow that rule to trigger at those designated times.
(Optional)
SourceAddressTranslation Action to take on source address. (Default: Auto)
NATSourceAddressAction Specify method to determine which sender
address to use. (Default: OutgoingInterfaceIP)
SATSourceAddressAction Specify method to determine which sender
address to use.
SourceNewIP Specifies which sender address will be used.
SourceBaseIP Specifies base address for sender address.
SourceNATPool Specifies NAT Pool to fetch sender address to be
used.
SourcePortAction Specify method to determine which port action to
use. (Default: None)
SourceNewSinglePort Translate to this port. (Optional)
SourceBasePort Transpose using this port as base. (Optional)
LogEnabled Enable logging. (Default: Yes)
LogSeverity Specifies with what severity log events will be sent
Chapter 3: Configuration Reference
210