3.60. IPPolicy
Description
An IP Policy specifies what action to perform on network traffic that matches the specified filter
criteria.
Properties
Index The index of the object, starting at 1. (Identifier)
Name Specifies a symbolic name for the policy.
Action Allow or Deny. (Default: Allow)
Reject Drop the packet and respond with an ICMP error or
TCP reset. (Default: No)
SourceAddressTranslation Action to take on source address. (Default: Auto)
NATSourceAddressAction Specify method to determine which sender
address to use. (Default: OutgoingInterfaceIP)
SATSourceAddressAction Specify method to determine which sender
address to use.
SourceNewIP Specifies which sender address will be used.
SourceBaseIP Specifies base address for sender address.
SourceNATPool Specifies NAT Pool to fetch sender address to be
used.
SourcePortAction Specify method to determine which port action to
use. (Default: None)
SourceNewSinglePort Translate to this port. (Optional)
SourceBasePort Transpose using this port as base. (Optional)
DestAddressTranslation Action to take on destination address. (Default:
None)
DestAddressAction Specify method to determine which destination
address to use.
DestNewIP Specifies which destination address will be used.
DestBaseIP Specifies base address for destination address.
DestPortAction Specify method to determine which port action to
use. (Default: None)
DestNewSinglePort Translate to this port. (Optional)
DestBasePort Transpose using this port as base. (Optional)
AntiVirus Anti-Virus scanning. (Default: No)
AV_Mode Anti-Virus mode. (Default: UsePolicy)
Chapter 3: Configuration Reference
200
To Next Page
Loading...
