3.55. IGMPRule
Description
An IGMP rule specifies how to handle inbound IGMP reports and outbound IGMP queries.
Properties
Index The index of the object, starting at 1. (Identifier)
Name Specifies a symbolic name for the rule. (Optional)
Type The type of IGMP messages the rule applies to.
(Default: Report)
Action Drop, Snoop, Proxy or PIM. (Default: Drop)
SourceInterface Specifies the name of the receiving interface to be
compared to the received packet.
SourceNetwork Specifies the sender span of IP addresses to be
compared to the received packet.
DestinationInterface Specifies the destination interface to be compared
to the received packet. (Default: core)
MulticastGroup Specifies the multicast group to be compared to
the received packet.
MulticastSource Specifies the multicast source to be compared to
the received packet.
RelayInterface Specifies the interface via which to relay IGMP
messages.
TranslateMGroup Translate the multicast group for packets matching
this rule. (Default: No)
GrpAllToOne Rewrite all multicast groups to a single IP. (Default:
No)
NewGrpIP Translate the multicast group to this address.
TranslateMSource Translate the multicast source for packets
matching this rule. (Default: No)
SrcAllToOne Rewrite all multicast sources to a single IP. (Default:
No)
NewSrcIP Translate the multicast source to this address.
Filter Pass IGMP data not matching this rule to the next
rule. (Default: Yes)
LogEnabled Enable logging. (Default: Yes)
LogSeverity Specifies with what severity log events will be sent
to the specified log receivers. (Default: Default)
Comments Text describing the current object. (Optional)
Chapter 3: Configuration Reference
193
To Next Page
Loading...
