D-Link DFL-870

Usage
ping [<String>] [-srcif=<interface>] [-srcip=<ip address>]
[-pbr=<table>] [-count=<1...10>] [-length=<2...8192>]
[-port=<0...65535>] [-udp] [-tcp] [-tos=<0...255>] [-verbose]
[-6]
Options
-6 Force IPv6.
-count=<1...10> Number of packets to send. (Default: 1)
-length=<2...8192> Packet size. (Default: 4)
-pbr=<table> Route using PBR Table.
-port=<0...65535> Destination port of UDP or TCP ping.
-srcif=<interface> Pass packet through the rule set, simulating that
the packet was received by <srcif>.
-srcip=<ip address> Use this source IP.
-tcp Send TCP ping.
-tos=<0...255> Type of service.
-udp Send UDP ping.
-verbose Verbose (more information).
<String> IP address or URL of host to ping.
2.3.3. traceroute
Trace route.
Description
Print the route packets take to a network host.
Usage
traceroute
Show help.
traceroute <String> [-starthop=<1...255>] [-maxhops=<1...255>]
[-timeout=<1...60000>] [-count=<1...10>]
[-size=<Integer>] [-pbr=<table>] [-srcip=<ip address>]
[-noresolve] [-nodelay] [-6]
Start trace.
Chapter 2: Command Reference
95