traceroute -stop
Stop trace.
Options
-6 Force IPv6 if target is a FQDN.
-count=<1...10> Number of queries to send for each hop. (Default:
3)
-maxhops=<1...255> Maximum number of hosts to traverse in search of
target. (Default: 30)
-nodelay Send queries as fast as possible (may look like
Denial of Service attack).
-noresolve Disable reverse DNS lookup of hosts.
-pbr=<table> Route using PBR Table.
-size=<Integer> Packet data size. (Default: 32)
-srcip=<ip address> Use this source IP.
-starthop=<1...255> Initial TTL value. (Default: 1)
-stop Stop trace in progress.
-timeout=<1...60000> How many milliseconds to wait for each reply.
(Default: 1000)
<String> IP address or FQDN of host to trace.
Chapter 2: Command Reference
96
To Next Page
Loading...
