ReachabilityRequired Specifies if this host is required to be reachable for
monitoring to be successful. (Default: No)
Samples Specifies the number of attempts to use for
statistical calculations. (Default: 10)
MaxPollFails Specifies the maximum number of failed attempts
until host is considered to be unreachable.
(Default: 2)
MaxAverageLatency Specifies the max average latency for the sample
attempts. (Default: 800)
RequestURL Specifies the HTTP URL to monitor.
ExpectedResponse Expected HTTP response.
Comments Text describing the current object. (Optional)
Note
If no Index is specified when creating an instance of this type, the object will be placed
last in the list and the Index will be equal to the length of the list.
3.110.2. Route6
Description
A route defines what interface and gateway to use in order to reach a specified network.
Properties
Name Specifies a symbolic name for the object.
(Optional)
Network Specifies the network address for this route.
Interface Specifies which interface packets destined for this
route shall be sent through.
Gateway Specifies the IPv6 address of the next router hop
used to reach the destination network. If the
network is directly connected to the firewall
interface, no gateway address is specified.
(Optional)
LocalIP The IPv6 address specified here will be
automatically published on the corresponding
interface. This address will also be used as the
sender address in ARP queries. If no address is
specified, the firewall's interface IPv6 address will
be used. (Optional)
Metric Specifies the metric for this route. (Default: 100)
ProxyNDAllInterfaces Always select all interfaces, including new ones, for
Chapter 3: Configuration Reference
287