object. May not be applicable depending on the
specified <Type>.
<key-value pair> One or more property-value pairs, i.e. <property
name>=<value>
or
<property
name>="<value>".
<Type> Type of configuration object to perform operation
on.
Note
Requires Administrator privileges.
2.1.11. show
Show objects.
Description
Show objects.
Show the properties of a specified object. There are a number of flags that can be specified to
show otherwise hidden properties. To show a list of object types and categories available in the
current context, just type show. Show a table of all objects of a type by specifying a type or a
category. Use the -errors or -changes flags to show what objects have been changed or
have errors in the configuration.
When showing a table of all objects of a certain type, the status of each object since the last time
the configuration was committed is indicated by a flag. The flags used are:
- The object is deleted.
o The object is disabled.
! The object has errors.
+ The object is newly created.
* The object is modified.
Additional flags:
D The object has dynamic properties which are updated by the system.
When listing categories and object types, categories are indicated by [] and types where objects
may be contexts by /.
Example 2.6. Show objects
Show the properties of an individual object:
gw-world:/> show Address IP4Address example_ip
gw-world:/main> show Route 1
gw-world:/> show Client DynDnsClientDyndnsOrg
Show a table of all objects of a type and a selection of their
Chapter 2: Command Reference
30
To Next Page
Loading...
