3.109. RoutingSettings
Description
Configure the routing capabilities of the system.
Properties
RouteFailOver_IfacePollInterval Time (ms) between polling of interface failure.
(Default: 500)
RouteFailOver_ARPPollInterval Time (ms) between ARP-lookup of gateways. May
be overridden for each route. (Default: 1000)
RouteFailOver_PingPollInterval Time (ms) between PING'ing of gateways. (Default:
1000)
RouteFailOver_GraceTime Time (s) between startup/reconfigure and
monitoring start. (Default: 30)
RouteFailOver_ConsecFails Number of consecutive failures before route is
marked as unavailable. (Default: 5)
RouteFailOver_ConsecSuccess Number of consecutive success before route is
marked as available. (Default: 5)
Transp_CAMToL3CDestLearning Do L3 Cache learning based on destination IPs and
MACs in combination with CAM table contents.
(Default: Yes)
Transp_DecrementTTL Decrement TTL on packets forwarded between
transparent interfaces. (Default: No)
Transp_CAMSize_Dynamic Allocate the CAM Size value dynamically. (Default:
Yes)
Transp_CAMSize Maximum number of entries in each CAM table.
(Default: 8192)
Transp_L3CSize_Dynamic Allocate the L3 Cache Size value dynamically.
(Default: Yes)
Transp_L3CSize Maximum number of entries in each Layer 3 Cache.
(Default: 8192)
Transp_RelaySTP Relay Spanning-Tree (STP, RSTP and MSTP) Bridge
Protocol Data Units to all switch interfaces.
(Default: Drop)
Transp_RelayMPLS Forward MPLS packets to all switch interfaces.
(Default: Drop)
Note
This object type does not have an identifier and is identified by the name of the type
only. There can only be one instance of this type.
Chapter 3: Configuration Reference
284
To Next Page
Loading...
