address to use.
SourceNewIP Specifies which sender address will be used.
SourceBaseIP Specifies base address for sender address.
SourcePortAction Specify method to determine which port action to
use. (Default: None)
SourceNewSinglePort Translate to this port. (Optional)
SourceBasePort Transpose using this port as base. (Optional)
DestAddressTranslation Action to take on destination address. (Default:
None)
DestAddressAction Specify method to determine which destination
address to use.
DestNewIP Specifies which destination address will be used.
DestBaseIP Specifies base address for destination address.
DestPortAction Specify method to determine which port action to
use. (Default: None)
DestNewSinglePort Translate to this port. (Optional)
DestBasePort Transpose using this port as base. (Optional)
SourceInterface Specifies the name of the receiving interface to be
compared to the received packet.
DestinationInterface Specifies the destination interface to be compared
to the received packet.
SourceNetwork Specifies the sender span of IP addresses to be
compared to the received packet.
DestinationNetwork Specifies the span of IP addresses to be compared
to the destination IP of the received packet.
SourceGeoFilter Specifies the country filter to be compared against
the sender Geolocation of the received packet.
(Optional)
DestinationGeoFilter Specifies the country filter to be compared against
the destination Geolocation of the received packet.
(Optional)
Service Specifies a service that will be used as a filter
parameter when matching traffic with this rule.
Schedule By adding a schedule to a rule, the firewall will only
allow that rule to trigger at those designated times.
(Optional)
LogEnabled Enable logging. (Default: Yes)
LogSeverity Specifies with what severity log events will be sent
to the specified log receivers. (Default: Default)
Comments Text describing the current object. (Optional)
Chapter 3: Configuration Reference
213
To Next Page
Loading...
