TLSRootCert Specifies the root certificates. (Optional)
HTTPInspection Enables HTTP protocol validation and logging of
URLs. (Default: No)
HTTPAllowUnknownProtocols Allow non-HTTP protocols to pass through without
inspection. (Default: No)
SourceInterface Specifies the name of the receiving interface to be
compared to the received packet.
DestinationInterface Specifies the destination interface to be compared
to the received packet.
SourceNetwork Specifies the sender span of IP addresses to be
compared to the received packet.
DestinationNetwork Specifies the span of IP addresses to be compared
to the destination IP of the received packet.
SourceGeoFilter Specifies the country filter to be compared against
the sender Geolocation of the received packet.
(Optional)
DestinationGeoFilter Specifies the country filter to be compared against
the destination Geolocation of the received packet.
(Optional)
Service Specifies a service that will be used as a filter
parameter when matching traffic with this rule.
Schedule By adding a schedule to a rule, the firewall will only
allow that rule to trigger at those designated times.
(Optional)
LogEnabled Enable logging. (Default: Yes)
LogSeverity Specifies with what severity log events will be sent
to the specified log receivers. (Default: Default)
Comments Text describing the current object. (Optional)
Note
If no Index is specified when creating an instance of this type, the object will be placed
last in the list and the Index will be equal to the length of the list.
Chapter 3: Configuration Reference
203
To Next Page
Loading...
