router will be declared to be down. (Default: 40)
RxmtInterval Specifies the number of seconds between
retransmissions of LSAs to neighbors on this
interface. (Default: 5)
RtrPrio Specifies the router priority, a higher number
increases this routers chance of becoming DR or
BDR, if 0 is specified this router will not be eligible
in the DR/BDR election. (Default: 1)
InfTransDelay Specifies the estimated transmit delay for the
interface in seconds. This value represents the
maximum time it takes to forward a LSA packet
trough the router. (Default: 1)
WaitInterval Specifies the number of seconds between the time
when the interface brought up and the election of
the DR and BDR. This value should be higher than
the hello interval. (Default: 40)
Passive Enable to make it possible to include networks into
the OSPF routing process, without running OSPF
on the interface connected to that network.
(Default: No)
IgnoreMTU Enable to allow OSPF MTU mismatches. (Default:
No)
Comments Text describing the current object. (Optional)
3.90.1.2. OSPFNeighbor
Description
For point-to-point and point-to-multipoint networks, specify the IP addresses of directly
connected routers.
Properties
Interface Specifies the OSPF interface of the neighbor.
IPAddress IP Address of the neighbor.
Metric Specifies the metric of the neighbor. (Optional)
Comments Text describing the current object. (Optional)
Note
If no Index is specified when creating an instance of this type, the object will be placed
last in the list and the Index will be equal to the length of the list.
3.90.1.3. OSPFAggregate
Chapter 3: Configuration Reference
257
To Next Page
Loading...
