D-Link DFL-870

HTTPBanners HTTP Authentication HTML Banners. (Default:
Default)
RealmString The string that is presented as a part of the 401 -
Authentication Required message. (Optional)
HostCertificate Specifies the host certificate that the firewall sends
to the client. Only RSA certificates are supported.
RootCertificate Specifies the root certificate that was used to sign
the host certificate. Only RSA certificates are
supported. (Optional)
PPPAuthNoAuth Allow no authentication. (Default: No)
PPPAuthPAP Use PAP authentication protocol. User name and
password are sent in plaintext. (Default: Yes)
PPPAuthCHAP Use CHAP authentication protocol. (Default: Yes)
PPPAuthMSCHAP Use MS-CHAP authentication protocol. (Default:
Yes)
PPPAuthMSCHAPv2 Use MS-CHAP v2 authentication protocol. (Default:
Yes)
IdleTimeout A successfully authenticated user will be logged
out automatically after this many seconds, if no
traffic has been received from the user's IP address.
(Default: 1800)
SessionTimeout A successfully authenticated user will be logged
out automatically after this many seconds, even if
traffic has been received from the user's IP address.
(Optional)
UseServerTimeouts Use timeouts received from the authentication
server. If no values are received, the manually
specified values will be used. (Default: No)
MultipleUsernameLogins Specifies how multiple username logins will be
handled. (Default: AllowMultiple)
ReplaceIdleTime Replace existing user if idle for more than this
number of seconds. (Default: 10)
AccountingServers Specifies the accounting servers that will be used
to report user usage matching this rule. (Optional)
PrimaryRetryIntervalAcc How many seconds to wait before trying to use the
primary server again if it has failed. (Default: 0)
BytesSent Enable reporting of the number of bytes sent by
the user. (Default: Yes)
PacketsSent Enable reporting of the number of packets sent by
the user. (Default: Yes)
BytesReceived Enable reporting of the number of bytes received
by the user. (Default: Yes)
PacketsReceived Enable reporting of the number of packets
Chapter 3: Configuration Reference
311