User Interface
88
DX8210 Barcode Scanner
Select the number of groups you wish to use from the Number of Groups drop-
down list. Then select the check box next to the Groups/Codes you wish to define.
Click Submit to save your selections, or click Cancel to return to the origin window
without saving.
The Group order defines the output message sequence, while each group identifies
an expected codes within the selected group.
When editing the logical combination rule, proceed as follows:
1. Define the Barcode Settings
indicating the type of expected code labels. It is
possible to define up to 10 different code types; These codes should be selected in
the Barcode Settings Table before Logical Combination is configured.
2. Define how many code types (groups) are expected by editing the combination
rule through the following logical operators. Each group may include one or more
selected code types.
& = AND operator which separates a group from the previous/following one;
^ = XOR operator to be used to combine different code labels within the
same group. It allows reading one of the defined code labels.
The maximum number of groups to be defined for each rule string is 15.
If Local No Read Message is selected from the No Read Message drop-down
list, the Group No Read Messages parameter is displayed. Define a Local No Read
String for each group.
To Next Page
Loading...
Need help?
General
