Reference Manual 21
Chapter 3
Electrical Installation
Preparing for Electrical Installation
Before mounting any components, please do the following:
• Read all instructions before beginning your installation.
• Observe all electrical safety requirements discussed in the Introduction to
this ma
nual.
• Define and confirm the accuracy of your application’s requirements.
• Review all installation-specific drawings.
• Review and plan the power requir
em
ents for your application.
• Review and plan the communications requirements for your application.
Electrical Installation by Qualified Service Technicians Only! Procedures may involve
exposure to high-voltage. A trained and authorized technician must perform these
procedures. Do not attempt to perform any electrical installation procedures unless
you are a trained technician.
The DS8110 barcode scanners contain electronics that may be affected by electrostatic
discharge (ESD). To prevent personal injury or damage to the unit, please follow the
safety precautions and warnings found in the References section at the beginning of
this manual. Failure to follow these precautions may void your warranty.
The content of this manual may be superseded by any customer-specific documenta-
tion provided by Datalogic. Before proceeding with any installation procedures, be sure
to review ALL documentation, especially content that contains details specific to your
installation.
To Next Page
Loading...
Need help?
General
