Datalogic DS8100 User Manual

Ethernet | Line Settings
Reference Manual 109
Ethernet | Line Settings
Use the Line Settings window to define and report the fundamental information
about the system.
To edit the Line Settings:
1. In the menu under Modify Settings, navigate to Global Settings | Ethernet |
Line
Se
ttings. The Line Settings window opens.
2. Enter the appropriate information in the form as described below:
Host Network (HOST)
Enable DHCP
Select the check box to cause the IP address parameters to become inactive. They
are then used to display the addresses assigned by a DHCP server.
Host IP Address
Enter the Internet Protocol (IP) network address for ETH2 (Setup) in the field
provided. Consult your network administrator to obtain a new address.Host IP
Netmask
Enter the device subnet mask address in the field provided. Consult your network
administrator to obtain a new address.
Host IP Gateway
Enter the device gateway address in the field provided. Consult your network
administrator to obtain a new address.
Host IP DNS1
Enter the address of the Primary Domain Name System (DNS) in the field provided.

Datalogic DS8100 Specifications

General

Brand	Datalogic
Model	DS8100
Category	Barcode Reader
Language	English