Connecting a PC to the DS8110
Reference Manual 27
Connecting a PC to the DS8110
During initial setup, a PC (laptop) may be connected to the DS8110 with a M12 to
RJ45 cable. Screw the M12 connector to the ETH 2 port of the scanner and plug
the RJ45 into the Ethernet port of your PC. If the ETH 2 port is in use, ETH 1 port
can be used. For information on connecting to e-Genius,
see Chapter .
Power Connector Pin-Out Table
A recommended power supply and cabling is available with the DS8110 and
DX8210 (and SC5000 Controller). However, if your installation requires custom
power supply wiring, the pin-outs of the unit power connector are provided
below for your convenience.
Power Connections
ETH2 is the Setup port, ETH1 is the HOST port.
A laptop can only communicate to a scanner that is connected to a CBX Connection Box
or SC5000 Controller.
Parameters for tunnel are set up in MASTER scanner (or SC5000 Controller) only.
When using a DS8110 barcode scanner, no power supply is required for the CBX510
connection box. All power and some communication options are fed to the CBX510
through the scanner’s 17-pin I/O connector to the CBX510 25-pin connector using the
cable provided.
In cases where the AS-I cabling is not used, the alternative CAB-LP-05 cable can be
used to connect the power supply to the scanner. Connect the Brown/White pair to +24
Vdc and the Blue/Black pair to 0 V- (GND).
When planning your installation wiring, remember all power connections must be
quick-disconnect.
The socket-outlet must be installed near the scanner. The outlet must be a readily
accessible disconnect device.
While performing the following wiring connection procedures, be sure to follow all
safety procedures regarding high-voltage as outlined in the Introduction to this man-
ual. No power should be applied to any device until all wiring is completed and checked
for accuracy.
To Next Page
Loading...
Need help?
General
