V1108, 8.23
name is created and opened to continue logging.
The following parameters show the events that can be logged. With each parameter it is
possible to program if the event should be logged or not. At least one of these parameters
should be switched on for logging.
Controller start. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..SA
Log event: the control has been started.
Controller stop. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..SO
Log event: the control has been stopped.
Step change . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..SC
Log event: the control has switched to the next bend step.
Product complete . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..PC
Log event: the last step of a bend program has been finished.
Mode change . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..MC
Log event: a different mode has been selected.
Error message . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..EM
Log event: an error message has occurred.
To Next Page
Loading...
