Delem DA-65W - Bend Parameters - Auxiliary Axes

V1108, 4.12
Decompression . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .DC
Decompression stroke after bending to release the working pressure
Pressing speed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .V
Working speed (pressing speed). Initially, the value for this parameter is copied from the
parameter ‘pressing speed’ in the programming constants menu.
Decomp speed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .BS
The decompression speed is the programmable speed which is active during the
programmed decompression stroke.
• Bend parameters - auxiliary axes
On this page, all programmable axes are shown. This page serves to have all axes positions
combined on one page in case they need to be changed. The axes shown here depend on the
machine configuration.
4.h
Auxiliary axis. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .R/Z/Aux.
If you have one or more auxiliary axes (for instance a R-axis, Z-axis or part support) the
parameters of these axes appear here.
Axis speeds
Speed of the selected axis in the current bend. Speed can be programmed in a percentage of
the maximum possible speed.
Retract
Retract distance of the selected axis in the current bend. If the retract distance of the X-axis is
altered in this window, the Retract parameter of the X-axis is automatically adjusted.