V1108, 4.13
Note:
After selecting a new bend this will be a copy of the preceding one; you only have to alter
those parameters which are different from the preceding bend.
• Bend parameters - all bends
When the function key ‘all bends’ has been pressed, a complete overview of the bends
appears. After pushing END the page from which this page was selected will be restored, with
the cursor on the parameter selected before.
4.i
A specific bend can be selected on the screen by putting the highlighted bar on that bend,
then pressing END.
From within this screen, the complete CNC program can be edited. All bend parameters can
be edited within the table and bends can be swapped, moved, added and deleted.
Function keys:
previous
page
To go to a previous page when available.
next page To go to a next page when available.
To Next Page
Loading...
