Delem DA-65W - 8.6. Production Settings

V1108, 8.11
Flattening offset. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..OF
The calculated depth position for the Y-axis beam in case of flattening your product
depends on the programmed flatten height of your special tool and the sheet thickness
(x2) and the here programmed offset to realise a flattened product as you require.
Z-distance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..ZD
The distance from the edge of the finger to the corner of the sheet.
When automatic Z-axes are installed, the position of the fingers is automatically
calculated with respect to the end of the sheet.
8.h
8.6. Production settings
8.i
Stock count mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..SC=
Setting for the stock counter in production mode, to have the stock counter (product
counter) count up or down.
When down counting is selected, the stock counter in production mode is decremented
after each press cycle. When the counter has reached zero, the control is stopped. On