V1108, 6.1
6. Programming of tools
6.1. Introduction
This chapter describes the programming of the tools and machine shapes.
6.2. Programming of Punches
6.2.1. The punch menu
The programming of punches is started by choosing Punch library in the main menu. The
punch profile can be created with help of the programming facilities of the control.
6.a
A listing of punches programmed into the memory is given.
Use the arrow keys to move the cursor bar to the
desired tool. Then press the ENTER key to edit this tool
or press the function key ‘edit’ to choose another
function.
To Next Page
Loading...
