V1108, 1.10
complete program can be executed bend after bend. In Step mode, each bend must be
started separately.
The manual mode of the control is an independent production mode. In this mode, one bend
can be programmed and executed. It is typically used to test the behaviour of the bend
system.
More information about this can be found in chapter 9 and 10.
1.6.7. Back-up data
Both product and tool programs can be stored externally. Depending on the configuration,
these files can be stored on a network or on a USB storage device. This facilitates a back-up
of important data and the possibility to exchange files between Delem controls.
More information about this can be found in chapter 7.
To Next Page
Loading...
