Delem DA-65W - Page 141

V1108, 9.3
Punch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..UP
The name (ID) of the applied punch.
Press the key to select the required setting.
Die . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..UN
The name (ID) of the applied die.
Press the key to select the required setting.
Use adapters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..UA
Program whether or not a tool adapter is used for this product. The use of an adapter
affects the calculated Y-axis position for all bends. Whether an adapter can be
programmed depends on the parameter ‘enable adapters’ in the programming
constants.
Press the key to select the required setting.
Material . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..MA
Selection of one of the programmed materials, which are used to calculate the bending
depths. The control contains 4 pre-programmed materials. In total, 99 materials can be
programmed on the control. See the chapter about programming constants how to
program materials.
Press the key to select the required setting.
Thickness . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..TH
Thickness of the sheet.
Bending length . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..BL
Length of the sheet between the tools.
Method . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..BM
Select the required bending method. The control supports 4 methods:
Air bend
Bottoming
Flattening
Flattening & bottoming
Press the key to select the required setting. See chapter 4 for more information about
possible bend methods.
Corr.
α. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..Cα
Correction on angle to bend
The angle correction should be entered as follows:
- Programmed value of 90 degrees.
- Measured value of 92 degrees.
Then it is required to program Corr._ with -2.
- Programmed value of 90 degrees.
- Measured value of 88 degrees.
Then it is required to program Corr._ with +2.
Angle. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..
α
Angle to bend.