V1108, 4.16
1Force
2 Decompression
3 Crowning device setting
4 Z-axis position offset
5 X-axis position correction
Parameters 1 through 4 are only automatically recalculated if the parameter Auto
computations edit (see the menu ‘program constants’) has been activated (value = 1).
Parameter 5 is only automatically recalculated if the parameter Bend allowance (see the
menu ‘program constants’) has been activated (value =1). Corrections on the X-axis position
can be edited with the parameter corr.X (per bend) and G-corr.X (for all the bends of the
active program) in the automatic and step-by-step mode.
For detailed information upon both parameters see the chapter about Automatic mode and
Step-by-step mode.
There is one exception: when the parameter bend method is changed the “force” and
“Decompression” will be adjusted automatically.
To Next Page
Loading...
