V1108, 6.9
6.k
Support type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..ST
Switch parameter, to account for differently mounted punches. Such punches could
cause inaccuracies in the tool height and the resulting Y-axis position. The control
makes a distinction between two settings, 'head mounted' and 'shoulder mounted'.
0 = shoulder mounted (default setting)
1 = head mounted
Press the key to select the required setting.
6.l
If 'shoulder mounted' is chosen, the Y-axis position is calculated from the standard tool height.
This is the default setting.
If 'head mounted' is chosen, a correction is made for Y-axis computation.
To Next Page
Loading...
