Dell PowerEdge XR8620t

2. Press the BOSS-N1 card and insert it firmly until the card is fully seated in the slot and locked to the latch on the system
board.
Figure 64. Installing the BOSS-N1 card
Next steps
Follow the procedure listed in Install the 2U top sled on the 2U node.
Removing the M.2 SSD module from the BOSS-N1 card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
1. Remove the screw that is on the BOSS-N1 card using Philips 2 screwdriver.
2. Pull the M.2 SSD module from the M.2 slot on the BOSS-N1 card.
96
Installing and removing system components