1 Temporarily tighten the solid collet.
Insert the solid collet into the spindle unit from below while holding the spindle unit immobile with a
wrench, and tighten temporarily.
Wrench
Spindle unit
Solid collet
2 Fully tighten the solid collet.
Using two wrenches, fully tighten the solid collet.
Wrench
Wrench
E
Assemble the nose unit.
There is a resin nose cone and a metal one. Select one and assemble.
¾ Resin nose cone: Use this when engraving a workpiece made from material that easily scratches.
¾ Metal nose cone: Use this when engraving a workpiece made from material that hardly scratches.
2 Tighten1 Place
Nose cone
Starting Engraving
44
Chapter 3 Basic Engraving Methods
To Next Page
Loading...
