5 Click [OK].
The [Engraving Parameters] screen closes.
H
Click [OK].
" P. 54 "Step 5: Starting Engraving"
Detailed Settings on the [Engraving Parameters] Screen
Detailed settings Explanation
XY Speed
This sets the speed at which the tool moves along X/Y axis during engraving.
Unit: mm/sec. (distance moved per second)
Z Speed
This sets the speed at which the tool moves along Z axis during engraving.
Unit: mm/sec. (distance moved per second)
Spindle
This sets the number of rotations of the spindle. This setting is disabled when
[Scribe] check box is selected.
Unit: rpm (number of rotations per minute)
Cutting-in Amount
This sets the cutting-in depth per time. Unit: mm or inch*
This setting is disabled when [Scribe] check box is selected.
The cutting-in amount is limited by the material of the workpiece. For the depth
that you cannot engrave at one time, perform cutting-in a few times to prevent the
cutting-in amount from exceeding its limit.
Tool-up Height
This sets the height at which the tool escapes along the Z-axis during engraving.
This setting is ignored when [AUTO Z CONTROL] on the handy panel is set to
[ON], and the height set with [SETTINGS] > [AUTO Z SETTING] on the handy
panel is enabled.
Unit: mm or inch*
Initialize Initializes all the settings congured under [Advanced Settings].
Save This saves the current setting values.
Load This loads the saved setting values.
* To switch between mm and inch units, click [File] - [Preferences].
Using Various Tools
96
Chapter 5 Various Engraving Methods
To Next Page
Loading...
