(g.58/C)
A
ANTI ROLL-OVER DEVICE
The machine is equipped with an electronic anti roll-over de-
vice (g.58/C Pos.“A”) which has the aim of helping the ope-
rator to use the machine safely by giving visual and acoustic
warnings when approaching the danger zone, according to
the load tables.
Before you start using the machine, the device must be pro-
grammed according to the attachment assembled on the boom.
The “operating mode” change from wheels/stabilisers,
front/360° is automatic.
An acoustic signal and a visual signal on the display (g.58/C
Pos.“A”) warn that the device has started to function.
Aggravating movements are automatically blocked (boom
descent and extension). The alarm ceases when safety con-
ditions are restored.
If an alarm is triggered while the hook or winch are
being used, the only movements that remain active are
the movements necessary to retract the boom and the
additional movements on the cable descent side.
If an alarm is triggered while the forks are being used,
the only movements that remain active are: retract boom,
raise boom, additional movements, plate pivot and turn.
If an alarm is triggered while the basket is being used,
the only movements that remain active are: retract
boom, raise boom, additional movements.
The anti roll-over device is always enabled.
- CAUTION:
The anti roll-over device cannot replace an operator’s ex-
pertise in operating the machine safely. The responsibility
for carrying out safe manoeuvres lies with the operator and
compliance with every prescribed safety standard.
- CAUTION:
The operator must be able to understand if the data supplied by
the instruments are correct and real. The data and the instruments
must be used if the machine is to be operated safely. When che-
cking the weight of a load, ensure the load is raised above ground.
When it is switched on, the device starts up a self-diagnosis
program to check if it and the transducers are functioning
properly. If there is a malfunction, the device places itself in
safety mode and blocks all manoeuvres.
Nevertheless, before starting to operate the machine, the ope-
rator must ensure that the instrument is functioning correctly:
- Check the dimensions indicated on the display.
- Check whether the panel is displaying any messages or alarms.
- Check that the manoeuvre blocking device is functioning properly.
- CAUTION:
Because the anti roll-over device is an electronic device with
numerous sensors, it can be subject to malfunctions or de-
fects. The operator must be able to identify malfunctions and
put them right as soon as possible by contacting an authori-
sed workshop or the DIECI service centre.
- CAUTION -
The operator is responsible for manual selection of the load
tables and therefore the limiting device. The last congura-
tion used remains active when automatic start up is used.
- CAUTION -
If the accessory is not programmed properly the device
may not function correctly and therefore create a
dangerous operating situation.
- CAUTION -
The selected table remains active even after
the machine has been switched off and on again.
It remains active until the subsequent manual selection.
- CAUTION -
The anti roll-over device and the “machine function
selector” are independent; therefore it is necessary to
rst manually program the “machine function selector”
and then the anti roll-over device.
The attachment selected with the “machine function
selector” must always correspond to the attachment
programmed on the control panel display.
It is forbidden to operate with different selections.
- CAUTION -
BEFORE STARTING TO OPERATE THE MACHINE,
THE OPERATOR MUST READ AND LEARN THE ANTI
ROLL-OVER DEVICE MANUAL WHICH HAS BEEN
INTEGRATED INTO THIS MANUAL.
To Next Page
Loading...
