Dieci Pegasus - Getting In and Out of the Cab

Getting to know and using the machine
C/8
Model E.T. PEGASUS
- CAUTION: - Read the SAFETY REGULATIONS (in this manual) carefully for the safety of all personnel and the machine.
(g.2/C1)
1
1
3
(g.1/C)
(g.2/C)
2
3
4
2
1
GETTING IN AND OUT OF THE CAB
Before getting in the cab, ensure your hands and shoes are
clean and dry to avoid slipping and falling.
Only use the grips (g.1/C Pos.“1”, “2” and “3”) to access the cab.
Do not use the controls or the steering wheel inside.
Always face the cab when getting in or out of your machine.
Before getting out of the machine, position the turret so that
the cab is aligned with the access steps (g.1/C Pos. “4”).
- CAUTION:
Only get out of the cab when it is aligned with the steps below.
Do not get out of or leave the machine when the turret is
positioned otherwise. (See the turret alignment pilot lamp on
Page C/15 - C/30)
DOOR CONTROLS
The cab door is equipped with an external handle with lock
(g.2/C Pos. “1”).
To open the door:
- Insert the key in the lock (fig.2/C Pos.“2”) and turn
clockwise/anticlockwise to lock/unlock.
- Pull the handle towards you to release the unlocked door.
NOTE:
The door will not open if you attempt to open the handle
when the door is locked.
- PROHIBITION -
IT IS STRICTLY FORBIDDEN to operate the machine
while the cab door is open.
INTERNAL DOOR HANDLE
- Move the handle upwards to release the door (g.2/C Pos. “3”).
- Push the door outwards to completely open.
- CAUTION:
Before pushing the door open, check there are no obstacles
in the way.