Dieci Pegasus - Page 37

B/17
- CAUTION -
ENTRAPMENT IN MOVING PARTS CAN CAUSE DAMA-
GE. TO PREVENT ACCIDENTS, ENSURE NO PARTS OF
YOUR BODY, HAIR OR CLOTHING CAN BECOME TAN-
GLED IN MOVING PARTS.
- DANGER -
ENGINE EXHAUST GASES ARE TOXIC AND CAN BE
HAZARDOUS FOR YOUR HEALTH.
- DANGER -
THE MACHINE MUST BE PLACED OUTDOORS WHILE
THE ENGINE IS RUNNING.
ONLY PLACE THE MACHINE INDOORS IF THE LOCA-
TION IS ADEQUATELY VENTILATED AND THE MACHINE
IS EQUIPPED WITH FILTERS.
- CAUTION -
IF YOU NEED TO WORK UNDER ANY RAISED MOBILE
PARTS, (BOOMS, SHOVELS, ETC.) BLOCK THE PARTS
WITH SPACERS PLACED ON THE CYLINDER RODS OR
PLACE THE PARTS ON ADEQUATELY SIZED SUPPORTS.
- Do not carry out any maintenance while the engine is run-
ning. If it is necessary to carry out maintenance work while
the engine is running, seek the assistance of at least two
workers and proceed as follows:
One person must remain seated in the driver’s seat, ready
to switch off the engine at any moment. All the workers must
continually maintain contact with each other.
Take the utmost care to avoid being trapped by components
while working near the fan, fan belt or other rotating parts.
Do not touch any levers or pedal controls. If it is necessary to
act on any lever or pedal, always tell the others to keep at a
safe distance.
Do not drop or insert any tools or other objects in rotating
machine parts; the parts can break or y into the air.
- If it is necessary to go underneath the attachment or the
machine to carry out maintenance work or to service parts,
rmly support the attachment and the machine with blocks
and supports solid enough to support the weight.
- Place any attachments removed from the machine in a safe
place, where they cannot fall. Adopt the due precautions to en-
sure that unauthorised people cannot enter the storage area.
- Do not place metallic parts on the battery.
- Any welding must be carried out by a qualied welder and
in a place with adequate equipment. While carrying out any
welding, there is a danger of gas leaks, fires and electric
shock; therefore ensure such work is not carried out by un-
qualied personnel.
- Disconnect the wires from the battery before acting on the elec-
trical system or before doing any arc welding on the machine.
- When carrying out electric welding, connect the ground ter-
minal of the welding machine as near as possible to the area
to be welded, to prevent the electric current from passing
through ball bearings, articulated joints, hydraulic cylinders
or reciprocal sliding parts. If welding is carried out near the
oil or fuel tank, drain them beforehand.